Appendix D: Factory Initialization Settings
D-2
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
Table D- 1: Factory initialization settings (Cont.)
Control Changed by Factory Init to
Edge trigger source Channel 1
Horizontal delay On
Horizontal delay time 0ns
Horizontal trigger position 10%
Horizontal time/doiv 400 s/div
Horizontal zoom Off
Horizontal zoom position 50%
Horizontal zoom time/div 400 s/div
Measure gating Off (Full Record)
Measure high-low setup Min-Max
Measure high reference 90% and 0 V (units)
Measure low reference 10% and 0 V (units)
Measure mid reference 50% and 0 V (units)
Overwrite lock No change
Reference waveforms No change
Saved setups No change
Trigger holdoff 250.8 ns
Trigger mode Auto
Trigger type Edge
Utility language No change
Utility date/time display On
Utility I/O No change
Utility hard copy No change
Vertical bandwi dth Full
Vertical coupl ing DC 1 MΩ
Vertical invert Off
Vertical offset 0V
Vertical position 0div
Vertical probe setup Voltage, 10 X, unless there is a probe att ached
Vertical volts/div 100 mV/div
Video trigger standard 525/NTSC
Video trigger on Any line
Waveform file format No change
To Next Page
Loading...
