Command Groups
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
2-43
Table 2- 28: Waveform commands (cont.)
Header Description
WFMPre:NR_Pt Sets or returns the the number of points in the
curve transfer to/from the oscilloscope
WFMPre:PT_Fmt Sets or returns the format of curve points
WFMPre:PT_Off? Query trigger offset
WFMPre:WFId? Query curve identifier
WFMPre:XINcr Sets or returns the horizontal sampling interval
WFMPre:XUNit Sets or returns the horizontal units
WFMPre:XZEro Sets or returns the time of first point in
waveform
WFMPre:YMUlt Sets or returns the vertical scal e factor
WFMPre:YOFf Sets or returns the vertical posi tion
WFMPre:YUNit Sets or returns the vertical units
WFMPre:YZEro Sets or returns the offset voltage
WFMPre:<wfm>? Query waveform preamble
WFMPre:<wfm>:NR_Pt Set the record length of the destination
reference waveform. Query the number of
points in the curve transfer from the oscillo-
scope.
WFMPre:<wfm>:PT_Fmt Sets or returns the format of curve points
WFMPre:<wfm>:PT_Off? Query trigger offset
WFMPre:<wfm>:WFId? Query curve identifier
WFMPre:<wfm>:XINcr Sets or returns the horizontal sampling interval
WFMPre:<wfm>:XUNit Sets or returns the horizontal units
WFMPre:<wfm>:XZEro Sets or returns the time of first points in a
waveform
WFMPre:<wfm>:YMUlt Sets or returns the vertical scale factor
WFMPre:<wfm>:YOFf Sets or returns the vertical posi tion
WFMPre:<wfm>:YUNit Sets or returns the vertical units
WFMPre:<wfm>:YZEro Sets or returns the offset voltage
To Next Page
Loading...
