Save/Recall
TDS3000 Series User Manual
3–41
Key Points
Saving to Disk. See Saved Waveform Formats on page 3–44 for
information about saving to and recalling from the disk.
Saving Setups. To save the current setup to nonvolatile memory, push
the Save Current Setup screen button and then select one of the ten
storage locations. Then, push the OK Overwrite Saved Setup screen
button to complete the operation or the MENU OFF button to cancel
the operation.
Recalling Setups. To recall a setup from nonvolatile memory, push the
Recall Setup screen button and then select one of the ten storage
locations.
Recalling the Factory Setup. Recall the factory setup to initialize the
oscilloscope to a known setup. Appendix B describes the Factory
Setup in detail.
To recall the factory setup, push the Recall Factory Setup screen
button. Then, push the OK Recall Factory Setup screen button to
complete the operation.
To Next Page
Loading...
Need help?
General
