Getting Acquain
tedWithYourInstrument
4. To display the s
ame measurements in
more than one tile, select each tile in
sequence, and then choose the same
measurement f
or each one.
The display at right shows the display
with WFM selected for three tiles.
NOTE. Audio a
nd Data List displays can be
displayed in only one tile at a time (unless
Option SIM is installed).
Setting Me
asurement Parameters
You can set up the measurements that you display using pop-up menus. Pop-up menus appear in the active tile. In general,
they control only settings specific to the active tile. For example, the pop-up menu for the Waveform display enables you
to set the Display Mode.
The pop-up menu will appear when called (see the procedure t hat follows), unless it is not appropriate for the current
instrument setting (for example, trying to display the Gamut m enu when viewing a composite input signal).
1. Select a tile by pressing one of the
numbered DISPLAY SELE CT buttons.
2. Push and hold the tile button for the
measurement that you d isplayed in
step 1.
3. When the menu pops up, navigate it and
make your selections as described in the
steps that follow.
Waveform Monitors Quick Start User Manual 21
To Next Page
Loading...
Need help?
General
