Telegesis ETRX357-LR - Page 10

R309 AT Commands
©2015 Telegesis (UK) Ltd - 10 - AT Command Manual (Rev 3.09)
Prompt Overview
FN130:[<EUI64>],<NWK addr>,<ioread>,
<sequence no>,<S46>,[<ADC0>],
[<ADC1>],[<ADC3>],[<ADC3>]
A data message has been received at the sink.
The number of ADC data fields depends on how
many ADCs are activated at the sender
FFD:<EUI64>,<NWK addr>
A router announcing itself
SED:<EUI64>,<NWK addr>
A sleepy end device announcing itself
MED:<EUI64>,<NWK addr>
A mobile sleepy end device announcing itself
ZED:<EUI64>,<NWK addr>
An end device announcing itself
NEWNODE: <NWK addr>,<EUI64>,
<Parent NWK addr>
Shown on Coordinator: New node has been given
permission to join the PAN. NB joining is not
complete until an “FFD” prompt or similar is
received
LeftPAN
Local Node has left the PAN
LostPAN
End Device has lost contact with Parent
JPAN:<channel>,<PID>,<EPID>
Local Node has joined PAN with given parameters
NODELEFT: <NWK addr>,<EUI64>
A device has left the PAN (shown on COO only)
ADSK:<EUI64>,<NWK addr>
Received Sink Advertisement
SREAD:<NWK addr>,<EUI64>,<Register>,
<errorcode>[=<Data>]
Reply to a remote S Register Read operation
SWRITE:<NWK addr>,<EUI64>,<errorcode>
Reply to a remote S Register Write operation
Bind:<NWK addr>,<status>
Create Binding Status
Unbind:<NWK addr>,<status>
Delete Binding Status
End Device Bind:<NWK addr>,<status>
End device binding status
DataMODE:<NWK addr>,<EUI64>
Datamode has been opened remotely
DataMODE:<NWK addr>,<EUI64>,
<errorcode>
Response to an attempt to open data mode
OPEN
Data mode is open
CLOSED
Data mode is closed
TRACK:<EUI64 R>,<EUI64 S>,<RSSI>,
<i/o read>,<ADC0>,<ADC1>,<Vcc>,<S46>
Tracking message: EUIs of receiver and sender,
RSSI, input data, Vcc & S46 counter of sender
(only the low-order 16 bits of S46 are shown)
TRACK2:<EUI64 R>,<EUI64 S>,<RSSI>,
<I/O read>,<S46>
Tracking message: EUIs of receiver and sender,
RSSI, I/O data, and S46 counter of sender
PWRCHANGE:XXXX
Local node has changed Power Mode to XXXX
AddrResp:<errorcode>
[,<NWK addr>,<EUI64>]
Response to an address request (also triggered
when finding source routes)
RX:<EUI64>,<NWK addr>,<profileID>,
<destinationEndpoint>,<SourceEndpoint>,
<clusterID>,<length>:<payload>
[,<RSSI>,<LQI>]
An incoming message not addressed to the AT
command endpoint. EUI64 is only shown if
included in network frame header
NM:ES REPORT WARNING
More than 16 energy scan reports have been
recently received by the network manager
indicating high packet loss
ENTERING BLOAD
Passthrough bootloading has been initiated from
another node
Table 3: Prompt Overview