R309 AT Commands
©2015 Telegesis (UK) Ltd - 111 - AT Command Manual (Rev 3.09)
S4E – End Device Poll Timeout
Register in a parent defining the amount of time
after which an SED or ZED times out of its
parent’s child table if it has not polled
Register in an SED or ZED defining the amount
of time after which it reports LostPAN when it
loses the parent
Operations
R/W LOCAL
R/W REMOTE
Becomes effective
After Soft or Hard Reset
Note
The timer tested according to S4E continues to
run in Power Mode 3
Storage
Non-Volatile
XXYY
Where YY is the timeout in seconds left-shifted
by XX (YY * 2^XX). The default number results
in a timeout of 5 Minutes, whereas the maximum
number results in a timeout of approximately 48
days.
Maximum
0EFF
Factory Default
0605
Register defining the MAC timeout
Operations
R/W LOCAL
R/W REMOTE
Becomes effective
After Soft or Hard Reset
Storage
Non-Volatile
Parameters
XXXX
The Ember_Indirect_Transmission_Timeout is
the amount of time in milliseconds that the MAC
in a parent node will hold a message for indirect
transmission to a child. In addition to this is also
the basis for the timeout after which an
acknowledged unicast to an end device is
nacked when no ack is received.
The default value is 7680ms.
The maximum is 30s
Maximum
7530
Factory Default
1E00
To Next Page
Loading...