AT+SENDUCAST:<Address>,<SourceEP>,
<DestEP>,<ProfileID>,<ClusterID>,<data>
<Address> - can be the remote node’s EUI64,
Network address, address table index or binding
table index.
<SourceEP> - 8-bit hexadecimal number,
specifying the source endpoint. For unicasts to
binding table entries, the source endpoint is
taken from register S40.
<DestEP> - 8-bit hexadecimal number,
specifying the destination endpoint. For unicasts
to binding table entries dummy 8-bit numbers
need to be specified for both endpoints, which
will be overwritten with the information from the
binding table.
Example
AT+SENDUCAST:0000,01,01,C091,0002,Test
Sends a Unicast to Coordinator
Notes
As a unicast command, AT+SENDUCAST is
subject to the same limits of payload length and
simultaneous messages as AT+UCAST.
SEQ and ACK are only reported when cluster
0002 is used.
Use on
All Devices
SEQ:XX
OK
or
ERROR:<errorcode>
Where <errorcode> represents the error code
explained in section 3.
Prompt
ACK:XX
or NACK:XX
If bit B of S10 is set, “SEQ”, “ACK” and “NACK”
are not reported. “OK” means that the message
has been acknowledged by the destination.
Please check ZigBee Cluster Library and HA
Profile for more information about constructing a
raw command
To Next Page
Loading...