Telegesis ETRX357-LR - Page 51

R309 AT Commands
©2015 Telegesis (UK) Ltd - 51 - AT Command Manual (Rev 3.09)
+IDENT – Play A Tune On Remote Devboard
Execute Command
AT+IDENT:<address>
Where <address> can be the remote node’s
EUI64, Network address or address table index
Use on
All Devices
Response
SEQ:XX
OK
or
ERROR<errorcode>
Prompt
ACK:XX
or NACK:XX
<errorcode> represents the error code explained
in section 3.
Plays a tune on a remote devboard if the Beeper
is connected. Useful to identify remote nodes.
See devkit manual for details about connecting a
buzzer to the ETRXn.
SW release
R300 ●