User Manual CXE85X
59300464 Rev.005
9.12.2013 20(44)
also be done via the front panel reset button. Note that these actions may result
in loss of communication and the viewer needs to be closed and reopened with
the new IP address.
RF output power
Clicking “Set limits to current value” button enables all alarm limits and sets the
alarms to ±3 and ±6 dB from the current measured value. Clicking “Use factory
limits” enables only low minor alarm limit and sets it to -15 dBm.
Optical input selection (CXE852 only)
When the input selection is set to the “Automatic” mode, the node automatically
selects the optical input according to signal conditions, see “Optical input
selection” section under “RF performance” chapter for details on its behavior.
In “Manual: RX #1” mode input 1 is used. In “Manual: RX #2” mode input 2 is
used.
To Next Page
Loading...