Televic Confidea G3 - Install Unit; Startup and Shutdown of Delegate Unit

12.
Information display: Indication of voting, volume and channel information.
13.
RFID card reader
14.
RF Status LEDs
Blue LED Indication of the condition of the RF connection.
Off : connection established
Blinking : searching connection
On : out of range
15.
Battery status LEDs
Red LED blinking the remaining operation time
1 Hz : 4h remaining
2Hz : 2h remaining
4Hz : 1h remaining
Units with the out of range LED on will be switched off after 2 minutes.
Install Unit
In order to use the Confidea WDU, first install the battery and microphone. For instructions, see "Battery
pack" on page30 and "Microphones" on page33. Disconnect the battery to avoid unwanted operation of
the unit. Keep the devices in a clean and dry area.
Startup And Shutdown Of Delegate Unit
To start up the delegate units simply press the microphone button for a few seconds until the LEDs start to
blink. When units are connected to a WCAP that is switched off , the units will go into sleep mode after
about 2 minutes, if no connection with another WCAP could be established.
If the delegate units are activated they will continue to search for a connection with a WCAP, so if no
connection with a WCAP could be established , the delegate units will remain on! To switch off the
delegate units or to deactivate the automatic sleep mode, remove the battery of the unit.
Mic led indications during startup or lost WCAP connection:
WIREL ESS CO NTRIBUTIO N UNITS 28