CONFIGURE CONFERENCE SETTINGS
Initialization
In stand-alone mode, the WCAP supports two kinds of initialization:
Open access: any unit can connect to the WCAP without an initialization procedure.
Manual initialization: a unit can only connect after it completes a certain procedure.
INITIALIZE UNITS THROUGH OPEN ACCESS
1.
Click the Menu icon and select Initialization.
2.
On the Initialization page select Open access. With this option the WCAP will detect all active
units (activate by pressing the microphone button) and add them to initialization list. Once a unit is
added its LED lights will turn off.
3.
To edit the name and add groups select Manual initialization and click Edit configuration. For
more information see "Edit units" on page64.
4.
Click Clear initialization to remove the current setup.
5.
Click Confirm to accept.
CONF IGURE CONF ERENCE SETTING S 62
To Next Page
Loading...
