If a unit is accidentally switched off during the update (e.g. due to empty battery) , this will
temporarily stop the update , but after a few minutes the update for the other units will
continue
6.
When the update is finished, click Continue to reboot the WCAP. After a delegate unit update,
only the devices will reboot.
7. When you return to the update page, you now see the firmware version you installed for the WCAP
and/or WDU’s.
Login Settings
Select Login settings ( ) in the main menu to change user name and password. Click Save settings to
save any changes made.
System Info
On the system info page you can find the following information:
Parameters Description
Device information Shows device specific information of the WCAP
System information Shows system information such as IP address and mode
License Place to upload your CoCon license, click
Upload license
Reboot WCAP Click
Reboot WCAP
to restart the device
SY STEM CO NF IG UR ATIO N 78
To Next Page
Loading...
