CONFIGURE FREQUENCY SETTINGS
Select Frequencies
1.
Click the menu icon and select Frequency settings.
The left part of the page shows which frequencies are selected (A). The frequency used by the
WCAP is indicated in green.
2. Select frequencies on the right part of the page (B), this list contains all available frequencies. Select
all frequencies in a category by clicking the checkbox next to the title (C) or select separate
frequencies (D). Frequencies that are not selected, will not be used.
You can see the strength of the signal by the amount and the colors of the bars next to the
frequency (E).
If you select more than one frequency, then the WCAP will automatically select a frequency from
the selection.
If other WCAPs are in the same IP network and their hostname is specified, then you can see
which frequencies they are using as their hostname is shown next to the frequency (F).
CONF IGURE FREQUENCY SETTING S 60
To Next Page
Loading...
