CONFIGURE NETWORK SETTINGS
Change IP Settings
1.
Click the Menu button and click the Network menu item. You can configure the following
settings:
Parameter Description
Hostname Change the hostname of the WCAP.
Address mode
Choose between static and DHCP mode:
Static: in this mode the IP address and subnet mask are fixed
and must be inserted into the appropriate fields.
DHCP: DHCP (Dynamic Host Configuration Protocol) is a
protocol used by the WCAP to automatically obtain the
parameters necessary for operation in an IP network. This
reduces system administration workload, allowing the WCAP to
be added to the network with little or no manual configuration.
There must be a DHCP server on the network that dynamically
assigns IP addresses when using the DHCP setting
IP address Enter the fixed IP address of the WCAP. (Only available in static
mode).
Subnet mask Define the subnet of the WCAP
Gateway Is the access point to another network.
API TCP port
CONF IGURE NETWO RK SETTING S 58
To Next Page
Loading...
