7. When ready click the Finish button.
8. After initial setup, change the IP address as described in "Configure IP settings" on page46 to
prevent conflicts when multiple access points with the same IP address are available in the network.
ACCESS THE CONFIGURED WCAP
1. On the computer connected to the WCAP, open your web browser and type the IP address of the
WCAP or wcap3.local in the address bar.
2. Press Enter.
3.
Enter the user name and password if configured otherwise just click Log in.
RETURN TO FACTORY SETTINGS
If you do not know the IP address then it is possible to reset the WCAP (reset to factory settings).
1. Press and hold the reset button next to the middle antenna for 10 sec. The web server shows you
how long you should keep the button pressed.
2. When you release the button a screen will appear to indicate that the device will reset. After this
action the IP address will be reset to its default value.
ACCESS THE WCAP WEB SERVER 53
To Next Page
Loading...
