CONFIGURE IP SETTINGS
Before you start using the Confidea G3 web server you need to configure your local IP settings to be able to
access the web server. Follow the procedure below to configure this.
To be able to access the web server your computer needs an IP address and subnet mask that can access
the IP address of the WCAP. The default IP address of the WCAP is 192.168.1.110, which means the
computer should have an IP address that is within the same subnet, like 192.168.1.11. The subnet mask
must be the same for all equipment on the network, being 255.255.255.0.
Change IP Settings In Windows
1.
Go to Control panel.
2.
Click Network and Internet and then Network and sharing center.
3.
Click Change adapter settings in the menu on the left.
CONF IGURE IP SETTING S 46
To Next Page
Loading...
