MANUALLY INITIALIZE UNITS
1.
Click the Menu icon and select Initialization.
2.
On the Initialization page select Manual initialization. To be able to detect the units, it must be
active (press the microphone button on the unit). If the unit did not detect the WCAP, its LED lights
will blink green. When it detects the WCAP the LED light will blink red.
3.
If there are already units present in the Initialization list click Clear initialization to remove the
current setup.
4.
Click Open initialization. When you start the new initialization, the microphone status LED’s on
all wireless units will start to blink red .
Microphone LEDs blinking red at a rate of 2 Hz is an indication that the units are trying to
connect to the WCAP.
Microphone LEDs blinking red at a rate of 1 Hz is an indication that the units are waiting
for the initialization.
5. To add a unit to the initialization list, press the microphone button of the unit (this is the button with
the following icon .
6. The LEDs will turn green indicating that the unit is added to the initialization list. Per unit the
following information is shown:
Parameters Description
Name Name of the unit, can be edited
Chairman icon A start icon indicates that this unit has chairman capabilities.
Serial number The serial number of the unit
Battery life Shows the remaining battery life of the unit
Packet loss (quality) Shows the number of packets lost during transmission, this affects
the quality of the sound. The higher the number, the lower the
quality.
7. Repeat step 5 until all units are added.
8.
Click Close initialization to save the setup. Only those units that were initialized are visible in the
Initialization list and are available to join the conference. This list remains available on the WCAP,
CONF IGURE CONF ERENCE SETTING S 63
To Next Page
Loading...
