WE310G4-I/P Module Hardware User Guide
1VV0301767 Rev. 5 Page 39 of 48 2022-11-08
Not Subject to NDA
autre antenne ou autre émetteur. L'antenne doit être installée de façon à garder une
distance minimale de 20 centimètres entre la source de rayonnements et votre corps.
FCC Class B digital device notice
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used by the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help.
CAN ICES-3 (B) / NMB-3 (B)
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de classe B est conforme à la norme canadienne ICES-003.
List of applicable FCC rules
Parts 15C, 2.1091
Part 15B
Part 15.247
Part 15.407
Part 2 Subpart J section 2.1091
Limited module procedures
N/A
Trace antenna designs
See 7.4 Antenna design
To Next Page
