EasyManua.ls Logo

Telit Wireless Solutions WE310G4-I - Page 40

Telit Wireless Solutions WE310G4-I
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WE310G4-I/P Module Hardware User Guide
1VV0301767 Rev. 5 Page 40 of 48 2022-11-08
Not Subject to NDA
Antennas
This radio transmitter has been approved by FCC and ISED to operate with the antenna
types listed below with the maximum permissible gain indicated. Antenna types not
included in this list, having a gain greater than the maximum gain indicated for that type,
are strictly prohibited for use with this device.
Type Max Gain
Omnidirectional 2.5dBi@2.4 GHz band and 4.5dBi@5 GHz band
Le présent émetteur radio a été approuvé par ISDE pour fonctionner avec les types
d'antenne énumérés ci-dessous et ayant un gain admissible maximal. Les types
d'antenne non inclus dans cette liste, et dont le gain est supérieur au gain maximal
indiqué, sont strictement interdits pour l'exploitation de l'émetteur.
Type Gain maximal
Omnidirectional 2.5dBi@2.4 band and 4.5dBi@5 GHz bands
Label and compliance information
The product has FCC ID and ISED label on the device itself. Also, the OEM host end
product manufacturer will be informed to display a label referring to the enclosed
module. The exterior label will read as follows:
Contains FCC ID: RI7WE310G4
Contains IC: 5131A-WE310G4
Information on test modes and additional testing requirements
The module has been evaluated in mobile stand-alone conditions. For different
operational conditions from a stand-alone modular transmitter in a host (multiple,
simultaneously transmitting modules or other transmitters in a host), additional testing
may be required (collocation, retesting…).
If this module is intended for use in a portable device, you are responsible for separate
approval to satisfy the SAR requirements of FCC Part 2.1093 and IC RSS-102.
Additional testing, Part 15 Subpart B disclaimer
The modular transmitter is only FCC authorized for the specific rule parts (such as FCC
transmitter rules) listed on the grant, and the host product manufacturer is responsible
for compliance with any other FCC rules that apply to the host not covered by the
modular transmitter grant of certification.