WE310G4-I/P Module Hardware User Guide
1VV0301767 Rev. 5 Page 44 of 48 2022-11-08
Not Subject to NDA
ALL OTHER CODES IN CONNECTION WITH THE SOFTWARE, INCLUDING (WITHOUT
LIMITATION) ANY WARRANTIES OF SATISFACTORY QUALITY OR FITNESS FOR A
PARTICULAR PURPOSE.
NO THIRD-PARTY LICENSORS OF OTHER CODES MUST BE LIABLE FOR ANY DIRECT,
INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES
(INCLUDING WITHOUT LIMITATION LOSS OF PROFITS), HOWEVER, CAUSED AND
WHETHER MADE UNDER CONTRACT, TORT, OR OTHER LEGAL THEORY, ARISING IN ANY
WAY OUT OF THE USE OR DISTRIBUTION OF THE OTHER CODES OR THE EXERCISE OF
ANY RIGHTS GRANTED UNDER EITHER OR BOTH THIS LICENSE AND THE LEGAL
TERMS APPLICABLE TO ANY SEPARATE FILES, EVEN IF ADVISED OF THE POSSIBILITY
OF SUCH DAMAGES.
11.2.6.
Waiver of Liability
IN NO EVENT WILL TELIT AND ITS AFFILIATES BE LIABLE FOR ANY DIRECT, INDIRECT,
SPECIAL, GENERAL, INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR EXEMPLARY
INDIRECT DAMAGE OF ANY KIND WHATSOEVER, INCLUDING BUT NOT LIMITED TO
REIMBURSEMENT OF COSTS, COMPENSATION OF ANY DAMAGE, LOSS OF
PRODUCTION, LOSS OF PROFIT, LOSS OF USE, LOSS OF BUSINESS, LOSS OF DATA OR
REVENUE, WHETHER OR NOT THE POSSIBILITY OF SUCH DAMAGES COULD HAVE
BEEN REASONABLY FORESEEN, CONNECTED IN ANY WAY TO THE USE OF THE
PRODUCT/S OR THE INFORMATION CONTAINED IN THE PRESENT DOCUMENTATION,
EVEN IF TELIT AND/OR ITS AFFILIATES HAVE BEEN ADVISED OF THE POSSIBILITY OF
SUCH DAMAGES OR THEY ARE FORESEEABLE OR FOR CLAIMS BY ANY THIRD PARTY.
Safety Recommendations
Make sure the use of this product is allowed in your country and the environment
required. The use of this product may be dangerous and has to be avoided in areas where:
it can interfere with other electronic devices, particularly in environments such as
hospitals, airports, aircraft, etc.
there is a risk of explosion such in gasoline stations, oil refineries, etc. It is the
responsibility of the user to enforce the country's regulations and the specific
environmental regulation.
Do not disassemble the product; any mark of tampering will compromise the warranty
validity. We recommend following the instructions of the hardware user guides for the
correct wiring of the product. The product has to be supplied with a stabilized voltage
source and the wiring has to be conformed to the security and fire prevention
regulations. The product has to be handled with care, avoiding any contact with the pins
because electrostatic discharges may damage the product itself. Same cautions have to
be taken for the SIM, checking carefully the instruction for its use. Do not insert or
remove the SIM when the product is in power-saving mode.
To Next Page
