Available options:
• Reading the settings from the device:
To read the settings from the device click on the “Read settings” button. This will
read all settings in all menus in the “Device settings” menu group.
• Writing the settings into the device:
After changing the settings or entering new settings, to take effect in the system,
it is necessary to write the settings into the device by clicking on the
“Write settings” button. This will write into the device the values changed in the
menus in the “Device settings” menu group.
• Edit an event:
To edit the settings of the selected event, click on the “Edit” button.
Please note that after you make changes, you must write the settings into the device
to be applied. For this, click on the “Write settings” button.
Event:
Input: the index number of the input that generates the given event. This data cannot be
changed.
Voice call:
Voice call notification: you can select from the drop-down menu, which phone number to be
notified by voice call when the given event occurs. The system will not play any sound or voice
message in the call. This function only serves to ring a phone number upon activating an input,
thus the notification will be of charge if the called person does not accept or rejects the call.
For this type of notification you can select one phone number per event. The phone numbers to
be notified can be configured in the “Reporting channels” menu.
Attention! If you are using the device model equipped with a 2G modem, or the device is
connected to the 2G network, when using functions that make an outgoing call, the Internet
connection will be interrupted for the duration of the call, because the 2G network does not
support voice calls and mobile Internet usage at the same time. In such a case, an outgoing
call will block the Internet connection, i.e., a possible remote connection in progress will be
suspended for the duration of the call.
Call duration: in this section you can configure the duration of a call in seconds, that is how long
the called phone device should ring. When the configured period expires, the system ends the
call automatically, or the called person may also reject the call earlier. The notification is free of
charge if the called person does not accept or rejects the call (please also check this with your
mobile service provider, because certain providers may apply a charge for rejected calls
as well).
Text-based notifications:
SMS notification: in this section you can select the phone numbers which you want to be
notified by SMS when the given event occurs. The phone numbers to be notified can be
configured in the “Reporting channels” menu. The text message will be sent to the numbers
enabled with the help of the checkboxes in the drop-down menu.
Message: in this field you can enter a custom message of maximum 45 characters, which you
want to be sent to the selected phone numbers when the given event occurs.
Attention! The following characters should not be used: ^ ~ < > = ' " , | ? $ & %
To Next Page
Loading...
