5.3 Users menu group
You can configure the user settings and remote access settings in the submenus available in the
“Users” menu.
Attention! The device handles the device settings and user settings (users, remote
access) as two different data categories, therefore you must read and write them
separately in the device.
• Changing the user or remote access settings:
To change the settings of user records or remote access records, you must read the user
you want to edit from the device. For this, you can read all users by clicking on the
“Read users” button in any submenu in the “Users” menu group, or you can use the
search tool by clicking on the “Search” button to read a specific user or users only.
If you haven’t read the device settings yet, the program will read these too automatically
before reading the users. After making changes in the user related settings, write the entries
into the device by clicking on the “Write users” button. If you have also changed the
device settings and you haven’t written the changes into the device yet, the program will
write these changes too before writing the users.
• Overwriting the full device configuration (device settings, users, and remote access
entries):
If you want to completely overwrite the users and the settings, you can import and write data
from a previously made system backup. To create a system backup file, configure the users
and the settings in the submenus, and then click on the “Create system backup”
button in the “General” device settings menu. You can import the saved backup into the
program using the “Restore from backup” button, and then write imported settings into
the device by category, using the “Write settings” and the “Write users” buttons.
To Next Page
Loading...
