Role: you can choose out of 3 role levels:
- User: can only control the system.
- Admin: can control the system and manage users (add/modify/delete).
- Super admin: full permission, can control the system and manage users and settings.
Added by: in this section, the system shows the identifier of the admin or super admin, who has
registered the new user. This is filled in automatically by the system. If the new user has been
added using the programming software, the system will show “Software” in this section.
Permissions:
0-24 entry period: if this option is enabled, the given user can control the system anytime over
the day. If this option is disabled, the given user can control the system over the day only within
the time interval configured in the “Permitted entry period” section in the “General” device
settings menu, i.e., control requests received from this user will be executed by the device within
the configured time period, and will be rejected outside the given period.
Trigger OUT1 upon control by call: if this option is enabled, the device will control output
OUT1 when the given user controls the system by call, or the user’s mobile application controls
the system by call, if controlling over the Internet fails due to a connection error.
Trigger OUT2 upon control by call: if this option is enabled, the device will control output
OUT2 when the given user controls the system by call, or the user’s mobile application controls
the system by call, if controlling over the Internet fails due to a connection error.
If you are using one of the control modes for 2 gates (control mode 1 or 2), you can enable
permissions for each user separately, to control output OUT1 only, output OUT2 only, or both
outputs at the same time. Unfortunately, it cannot be determined from a call, which output the
user would like to control, therefore it needs to be configured in advance with this option,
which output (or both at the same time) the system should control in such a case.
➢ Adding a new user:
• Click on the “Add new” button.
• Enter the user’s username and phone number.
• Select the user’s role.
• Configure the user’s permissions.
• Click on the “OK” button.
• Click on the “Write users” button.
To Next Page
Loading...
