136
It is possible to configure some sort of MQTT publisher. It is not simple publisher, but publisher, which publishes
some system parameters to the broker. The publisher configuration window has few fields, like hostname and port of
the broker to connect. Username and password fields are used for authentication. If these fields are left empty, no
authentication is performed.
The full list of system parameters, which can be published, are described below.
Get temperature of the module in 0.1 degrees Celcium
Get current operator’s name
Get signal strength in dBm
Get current network type (2G, 3G, 4G, etc’)
To Next Page
Loading...
Need help?
General
