75
Protocol of the packet that is being matched against traffic
rules.
Match incoming traffic from selected address family only
Forward incoming traffic to selected address family only
Rewrite to source IP 10.101.1.10
SNAT (Source Network Address Translation) rewrite packet\'s
source IP address and port
Make a rule active/inactive
You can configure firewall source NAT rule, by clicking edit button.
Used to make rule management easier
Protocol of the packet that is being matched against
traffic rules.
Match incoming traffic from this zone only
Match incoming traffic from these MACs only
Match incoming traffic from this IP or range only
Match incoming traffic originating from the given source
port or port range on the client host only
Match forwarded traffic to the given destination zone
only
Match forwarded traffic to the given destination IP
address or IP range only
Match forwarded traffic to the given destination port or
port range only
To Next Page
Loading...
Need help?
General
