Tenda N60 - WAN Access Control

Concurrent Dual Band Wireless N600 Gigabit Router
Click “Save” to display the following page. Select “Allow” from the “Default”
drop-down list and check the “Enable MAC Filter” feature as below.
4.3.5 WAN Access Control
The WAN Access Control feature allows users to configure your router from Internet
via a web browser.
 Enable: Check or uncheck to enable or disable the WAN Access Control feature.
 Port: Enter a port ID for remote web-based management. The default is 8080.
 IP Address: Enter the IP address of a PC on Internet authorized to access and
manage your router’s web-based utility remotely.
31