Concurrent Dual Band Wireless N600 Gigabit Router
6) PPPOE Dual Access
Internet connection Type: Displays a list of available Internet connection
types.
Username: Enter the PPPOE account provided by your ISP.
Password: Enter the PPPOE password provided by your ISP.
Address mode: Select “Dynamic” if you don’t get any IP info from your ISP,
otherwise select “Static”.
IP address: The IP address provided by your ISP. Inquire your local ISP if you are
not clear.
Subnet mask: The subnet mask provided by your ISP.
Default Gateway: The gateway address provided by your ISP. Inquire your local
ISP if you are not clear.
MTU: Maximum Transmission Unit. The default value is 1492.
4.2.3 DHCP Settings
“DHCP” includes 3 submenus: DHCP Server, Client List and Static Assignment.
Clicking any of them enters corresponding interface for configuration. Below
explains, in details, each such feature.
The Dynamic Host Configuration Protocol (DHCP) is an automatic configuration
protocol used on IP networks. If you enable the built-in DHCP server on the device,
it will automatically configure the TCP/IP settings for all your LAN computers
(including IP address, subnet mask, gateway and DNS etc), eliminating the need for
manual intervention. Just be sure to set such PCs to DHCP clients by selecting
“Obtain an IP Address Automatically” on each such PC. When you turn these PCs on,
they will automatically load the proper TCP/IP settings provided by the device
DHCP server.
19
To Next Page
Loading...
Need help?
General
