Tenda XPON ONT HG1 - Page 31

Document version: V1.0
25
Parameter
Description
802.1p_Mark
This parameter is available only when the Enable VLAN function is enabled. It specifies
the 802.1P priority. Data with a larger priority value takes a higher priority to be
processed.
Channel Mode
Specifies the mode that you used to set up the WAN connection, including Bridged,
IPoE and PPPoE.
⚫
Bridged: Select this type when this device only serves as a modem, and you want to
set up a dial-up connection or enter other internet parameters directly on your
computer for internet access.
⚫
IPoE: Select DHCP if your ISP does not provide any parameters to you for internet
access, and select Fixed IP if your ISP provides a static IP address and other related
information to you for internet access.
⚫
PPPoE: Select this type if your ISP provides a user name and password to you for
internet access.
Admin Status
Specifies whether to enable this WAN connection.
Connection Type
Specifies the WAN connection type. It is INTERNET by default.
MTU
Maximum Transmission Unit (MTU) is the largest data packet transmitted by a network
device. When the channel mode is PPPoE, the default MTU value is 1492. When the
channel mode is IPoE, the default MTU value is 1500. Do not change the value unless
necessary.
IP Protocol
Specifies the adopted IP protocol version.
⚫
IPv4: Select this option if IPv4 is used for communication.
⚫
IPv6: Select this option if IPv6 is used for communication.
⚫
IPv4/IPv6: Select this option if both IPv4 and IPv6 are used for communication.