Tenda XPON ONT HG1 - WAN IP settings

Document version: V1.0
26
6.2 WAN IP settings
You can configure the WAN IPv4 address information in this part.
This part needs to be configured only when Channel Mode is set to IPoE and IP Protocol is set to
IPv4 or IPv4/IPv6.
Parameter description
Parameter
Description
Type
Specifies the method used by the ONT to obtain WAN IP address information.
⚫
Fixed IP: You need to configure the local IP address, remote IP address (gateway
address) and other related information manually.
⚫
DHCP: The ONT obtains WAN IP address information automatically. Choose this type if
your ISP does not provide related parameters.
Local IP Address
If you select Fixed IP for Type, you should manually enter the IP address and related
information provided by your ISP.
Remote IP Address
Subnet Mask
IP Unnumbered
Used to make multiple ports to share one IP address.
Request DNS
If the IP address is obtained through DHCP, you can select Request DNS to obtain the
DNS server address automatically.
Primary DNS Server
If the IP address obtaining type is Fixed IP or Request DNS function is disabled when the
IP address obtaining type is DHCP, you should enter the DNS server address provided by
your ISP.
If the ISP only provides one DNS server address, you can leave the secondary DNS blank.
Secondary DNS
Server