Tenda XPON ONT HG1 - Scenario 1: HGU ONT; Bridge Mode

Document version: V1.0
3
1.2 Scenario 1: HGU ONT
1.2.1 Bridge mode
If you have a router and want to set up internet access on it, or you only want to access the
internet on a certain computer, you can use the ONT under bridge mode.
‒ When the ONT is under bridge mode, you can only access the internet through the downstream
device used for setting up internet access.
‒ If you use the Ethernet cable to connect the LAN port of the ONT to the computer without the
router, you can access the internet without configuring the computer.
Under bridge mode, the ONT acts as a bridging device between your LAN and your ISP. The ONT
works under bridge mode by default.
Configure the ONT
When the ONT is set to the bridge mode, you can configure the related parameters of the ONT
according to your ISP and your own need.
Step 1
Log in to the web UI of the ONT.
Step 2
Navigate to WAN > WAN > PON WAN.
Step 3
Tick Enable VLAN.
Step 4
Enter the VLAN ID provided by your ISP.
Step 5
Set Channel Mode to Bridged.
Step 6
Set Connection Type to INTERNET.
Step 7
Set other parameters according to your ISP and your own need.
Step 8
Click Apply Changes.
---End
After the configuration is completed, you can configure a computer or a router to dial-up.