Tenda XPON ONT HG1 - IPv6 WAN settings

Document version: V1.0
27
6.3 IPv6 WAN settings
You can configure the WAN IPv6 address information in this part.
When IP Protocol is set to IPv6 or IPv4/IPv6, and Channel Mode is set to IPoE or PPPoE, these
parameters are required.
Parameter description
Parameter
Description
Address Mode
Specifies how the WAN IPv6 address of the ONT is obtained, including Slaac and Static.
⚫
Slaac: Stateless Address Autoconfiguration (SLAAC) is a dynamic allocation method of
IPv6 address, which enables the ONT to auto-generate IPv6 addresses with local
information and those from the router advertisement.
⚫
Static: You need to enter parameters related to IPv6 address manually.
IPv6 Address
Specifies the IPv6 address and prefix length provided by your ISP when you select Static
for Address Mode.
IPv6 Gateway
Specifies the IPv6 gateway address of the ONT when you select Static for Address
Mode.
Primary IPv6 DNS
Specify the primary and secondary DNS server addresses of the ONT.
Secondary IPv6 DNS
Enable DHCPv6
Client
Specifies whether to enable the DHCPv6 client function.
Request Options
You can enable the ONT to obtain the address or prefix as a DHCPv6 client.