Tenda XPON ONT HG1 - Page 57

Document version: V1.0
51
Parameter description
Parameter
Description
Enable
Specifies whether to enable the static route function.
Destination
Specifies the IP address of the destination network.
Subnet Mask
Specifies the subnet mask of the destination network.
Next Hop
Specifies the ingress IP address of the next hop route after the data packet exits from
the WAN interface of the ONT.
Metric
Specifies the priority of the routing rule. The smaller the number, the higher the priority.
When the destination networks of two rules are the same, packets will be forwarded
according to the rule with smaller metric.
Interface
Specifies the interface of the ONT that the packet exits from.
Add Route
Used to add a new static route rule.
Update
Used to update your modification to an existing rule.
Delete Selected
Used to delete the selected rule.
Show Routes
Used to display the commonly used routes of the ONT.
Select
Select existing rules to update or delete them.
State
Specifies the status of a rule, including Enable and Disable.
Add a new static route rule
Step 1
Log in to the web UI of the ONT.
Step 2
Navigate to Advance > Advance > Routing.
Step 3
Select Enable as required.
Step 4
Set Destination, Subnet Mask, Next Hop, Metric and Interface as required.