Terex MAC 25 User Manual

MAC-25 FALL BLOCK LOAD CHART - 40 DEG. ART
.
LMI DUT
Y
201
COUNTERWEIGHT ON REAR OF CRANE - SPRING LOCKOUTS ENGAGED S.W.L. ARE BASED ON 66.7% STABILITY & STRENGTH
S.W.L IN KILOGRAMS FOR SLEW ANGLES OF GREATER THAN 10 DEGREES UP TO 40
- S.W.L. ABOVE BOLD RED LINE ARE STRUCTURAL
DEGREES EITHER SIDE OF STRAIGHT AHEAD (INDICATED BY RED LED ON DASH).
S.W.L. ARE BASED ON FIRM LEVEL GROUND (1% SLOPE (0.6 DEG) AS PER AS1418.5)
BOOM ANGLE - UNDEFLECTED (REF.)
WITH TYRES INFLATED AS PER NOTES
LIFT & CARRY - THE S.W.L. SHALL BE CARRIED WITH THE MINIMUM BOOM LENGTH & AS
NOTE :
VALUES IN BRACKETS ( ) ARE ACTUAL RADIUS AT ZERO DEG. BOOM ANGLE.
CLOSE TO THE GROUND AS POSSIBLE AT SPEEDS NOT IN EXCESS OF 0.4 M/SEC (1.44 KM/HR)
Radius BOOM PIVOT TO HEAD SHEAVES - THIRD BOOM RETRACTED THIRD BOOM EXTENDING
in
(metres) (metres)
Metres 6.12 6.50 7.00 7.50 8.00 8.50 9.00 9.50 10.00 10.50 11.00 11.50 12.00 12.50 13.00 13.50 14.32 14.50 15.00 15.50 16.00 16.50 17.00 17.50 18.00 18.42
1.4
21750 20200 18550 17250 16150 15200 14400 13700
48 51 54 57 59 61 63 65
2.0
19850 18700 17500 16150 15000 14100 13300 12600 12000 11450 10950
WINCH S.W.L.
40 44 48 51 54 57 59 61 62 64 65 SINGLE PART 4200
2.5
16250 16250 15600 14700 13900 13200 12400 11750 11150 10650 10200 9800 9400 TWO PARTS 8400
32 37 42 46 50 52 55 57 59 61 62 63 65 FOUR PARTS 16800
3.0
13300 13300 13250 13250 12500 11900 11400 10900 10400 9900 9500 9100 8750 8450 8150 7850 SIX PARTS 25000
21 29 35 41 45 48 51 53 55 57 59 61 62 63 64 65
3.5
11450 11150 11150 11150 11100 10800 10300 9900 9500 9200 8800 8450 8150 7850 7600 7350 6950 6900
(3.4) 17 28 34 39 43 47 49 52 54 56 58 59 61 62 63 65 65
4.0
10150 9550 9550 9550 9550 9400 9000 8650 8350 8100 7850 7550 7300 7050 6850 6500 6450 6300 6150
(3.8) 17 27 33 38 42 45 48 51 53 55 56 58 59 61 62 63 64 65
5.0
8750 7700 7350 7300 7300 7300 7300 7100 6850 6600 6400 6250 6100 5950 5650 5600 5500 5400 5300 5200 5100 5050 4950
(4.3) (4.8) 16 25 31 36 40 43 46 48 50 52 54 56 58 58 59 61 62 63 63 64 65
6.0
6800 6100 5850 5850 5800 5800 5800 5700 5550 5350 5200 5100 4900 4850 4800 4750 4650 4600 4550 4450 4400 4350
(5.3) (5.8) 15 24 30 34 38 41 44 46 48 50 53 53 55 56 57 58 60 61 61 62
7.0
5450 4950 4750 4750 4750 4750 4750 4700 4550 4450 4250 4250 4200 4150 4100 4050 4000 3950 3900 3850
(6.3) (6.8) 14 23 28 33 36 39 42 44 48 48 50 52 53 54 56 57 58 59
8.0
4500 4100 3950 3950 3950 3950 3950 3900 3750 3750 3700 3650 3600 3600 3550 3500 3500 3450
(7.3) (7.8) 13 22 27 31 35 38 42 43 45 47 48 50 51 53 54 55
9.0
3750 3450 3350 3350 3350 3350 3350 3350 3300 3250 3200 3200 3150 3150 3100 3100
(8.3) (8.8) 13 21 26 30 35 36 39 41 43 45 47 48 50 51
10
3150 2950 2850 2850 2850 2850 2900 2900 2900 2850 2850 2800 2800 2750
(9.3) (9.8) 12 20 28 29 32 35 38 40 42 44 45 47
11
2700 2500 2450 2450 2500 2550 2550 2600 2550 2550 2500 2500
(10.3) (10.8) 17 19 24 28 31 34 37 39 41 42
12
NOTE : WEIGHT OF HOOKS, BLOCKS & OTHER 2200 2150 2150 2200 2250 2250 2300 2300 2300 2300
LOAD HANDLING DEVICES SHALL BE ADDED (11.6) (11.8) 12 19 23 27 30 33 36 37
13
TO THE WEIGHT OF THE LOAD 2050 1950 1950 2000 2000 2050 2050 2100
(12.3) (12.8) 11 18 23 27 30 32
14
1850 1750 1750 1800 1800 1850
(13.3) (13.8) 11 18 22 25
15
1700 1600 1600 1650
(14.3) (14.8) 10 16
15.71
1550 1500
(15.3) (15.7)
34/66 MXC1347B COUNTERWEIGHT - REAR MAC 25 FALL BLOCK - 40 DEG

Terex MAC 25 Specifications

General

Brand	Terex
Model	MAC 25
Category	Construction Equipment
Language	English