Terex MAC 25 - Page 42

MAC-25 OFFSET HEAD TOP POSITION LOAD CHART - 40 DE
G
LMI DUT
Y
204
COUNTERWEIGHT ON REAR OF CRANE - SPRING LOCKOUTS ENGAGED
S.W.L. ARE BASED ON 66.7% STABILITY & STRENGTH
S.W.L IN KILOGRAMS FOR SLEW ANGLES OF GREATER THAN 10 DEGREES UP TO 40
- S.W.L. ABOVE BOLD RED LINE ARE STRUCTURAL
DEGREES EITHER SIDE OF STRAIGHT AHEAD (INDICATED BY RED LED ON DASH).
S.W.L. ARE BASED ON FIRM LEVEL GROUND (1% SLOPE (0.6 DEG) AS PER AS1418.5)
BOOM ANGLE - UNDEFLECTED (REF.)
WITH TYRES INFLATED AS PER NOTES
NOTE :
VALUES IN BRACKETS ( ) ARE ACTUAL RADIUS AT ZERO DEG. BOOM ANGLE.
LIFT & CARRY - THE S.W.L. SHALL BE CARRIED WITH THE MINIMUM BOOM LENGTH & AS
CLOSE TO THE GROUND AS POSSIBLE AT SPEEDS NOT IN EXCESS OF 0.4 M/SEC (1.44 KM/HR)
Radius BOOM PIVOT TO EDGE OF SHEAVE - THIRD BOOM RETRACTED THIRD BOOM EXTENDING
in (metres) (metres)
Metres 6.82 7.00 7.50 8.00 8.50 9.00 9.50 10.00 10.50 11.00 11.50 12.00 12.50 13.00 13.50 14.00 14.50 15.02 15.50 16.00 16.50 17.00 17.50 18.00 18.50 19.12
1.4
8400 8400 8400 8400 8400 8400 8400
52 53 56 58 60 62 64
2.0
8400 8400 8400 8400 8400 8400 8400 8400 8400 8400
WINCH S.W.L.
45 47 50 53 56 58 60 61 63 64 SINGLE PART 4200
2.5
8400 8400 8400 8400 8400 8400 8400 8400 8400 8400 8400 8400 TWO PARTS 8400
39 41 45 49 52 54 56 58 60 61 63 64
3.0
8400 8400 8400 8400 8400 8400 8400 8400 8400 8400 8400 8400 8400 8250 7950
32 34 40 44 47 50 53 55 57 58 60 61 63 64 65
3.5
8400 8400 8400 8400 8400 8400 8400 8400 8400 8400 8400 8250 7950 7650 7400 7200 6950
24 27 33 38 42 46 49 51 53 55 57 59 60 61 62 63 64
4.0
8400 8400 8400 8400 8400 8400 8400 8400 8400 8250 7950 7700 7400 7150 6900 6700 6500 6300 6150
(4.1) 16 26 32 37 41 45 47 50 52 54 56 57 59 60 61 62 63 64
5.0
8400 7900 7550 7500 7500 7450 7450 7200 6950 6750 6550 6350 6200 6000 5850 5700 5500 5400 5300 5200 5100 5050 4950
(4.3) (4.8) 15 24 30 35 39 42 45 48 50 52 53 55 56 58 59 60 61 62 63 64 65
6.0
7000 6250 6000 6000 5950 5950 5950 5850 5650 5450 5300 5200 5050 4950 4800 4750 4700 4600 4550 4450 4400 4300 4250
(5.3) (5.8) 14 23 29 34 37 40 43 46 48 50 51 53 54 56 57 58 59 60 61 62 63
7.0
5650 5100 4900 4900 4900 4850 4850 4800 4650 4550 4400 4300 4200 4150 4100 4050 4000 3950 3900 3850 3800
(6.3) (6.8) 14 22 28 32 36 39 41 44 46 48 50 51 53 54 55 56 57 58 59
8.0
4650 4250 4100 4100 4050 4050 4050 4000 3900 3800 3700 3650 3600 3600 3550 3500 3500 3450 3400
(7.3) (7.8) 13 21 27 31 34 37 40 42 44 46 48 49 51 52 53 55 56
9.0
3900 3550 3450 3450 3450 3400 3400 3400 3300 3250 3200 3200 3150 3150 3100 3100 3050
(8.3) (8.8) 12 20 25 30 33 36 39 41 43 45 46 48 49 51 52
10
3300 3050 2950 2950 2900 2900 2900 2950 2900 2850 2850 2800 2800 2750 2750
(9.3) (9.8) 12 19 25 29 32 35 37 40 42 43 45 47 48
11
2800 2600 2500 2500 2500 2550 2600 2600 2550 2550 2550 2500 2500
(10.3) (10.8) 12 19 24 28 31 34 36 38 40 42 44
12
NOTE : WEIGHT OF HOOKS, BLOCKS & OTHER 2400 2250 2150 2200 2250 2250 2300 2350 2300 2300 2250
LOAD HANDLING DEVICES SHALL BE ADDED (11.3) (11.8) 12 18 23 27 30 33 35 37 40
13
TO THE WEIGHT OF THE LOAD 2050 1950 1950 2000 2000 2050 2050 2100 2050
(12.3) (12.8) 11 18 22 26 29 32 35
14
1850 1800 1750 1800 1800 1850 1900
(13.3) (13.8) 11 17 22 25 29
15
1700 1600 1600 1650 1650
(14.3) (14.8) 10 17 22
16.45
1550 1500 1400
(15.3) (15.8) (16.5)
40/66 MXC1347B COUNTERWEIGHT - REAR MAC 25 OFFSET HEAD TOP POSITION - 40 DEG