Technical Data
9-6
Brakes
The machine has a full hydraulic braking system with enclosed, oil-immersed multiple discs on each wheel.
Independent circuits serve the front and the rear brake systems. Warning lights and audible alarm indicate low
brake system pressure. The brake systems conforms to ISO 3450, SAE J1473.
Actuating Pressure.............................................60 bar (870 lbf/in²)
Braking surface..................................................22000 mm2 (34.1 in²)
Parking: Spring-applied, hydraulic-released disc on the rear driveline.
Emergency: There is automatic application of the driveline brake should pressure fall in the main brake hydrau-
lic system. Service brakes may also be applied using the parking-emergency brake control.
Retardation: Standard exhaust brake and standard hydraulic retarder integral with transmission.
Steering
Hydrostatic power steering is provided by two single-stage, double-acting, cushioned steering cylinders. Emer-
gency steering pressure is provided by a ground driven pump mounted on the rear of the transmission. An
audible alarm and warning light illuminates should the emergency system activate. Conforms to ISO 5010,
SAE J53.
System Pressure................................................241 bar (3500 lbf/in²)
Steering Angle to either side..............................45°
Lock to Lock Turns, steering wheel....................4
Body Hoist
Two single-stage, double-acting hoist rams, cushioned at both ends of stroke.
Electro servo assisted hoist control.
System Pressure................................................220 bar (3200lbf/in²)
Control Valve......................................................Pilot Operated, Closed
Centre
Body Raise Time (loaded)..................................12 sec
Body Lower Time (power down).........................7.5 sec
ELECTRICAL SYSTEM
Type....................................................................24 volt, Negative Ground
Battery.................................................................Two,12 Volt, 143 Ah each
Accessories.........................................................24 Volt
Alternator............................................................70 Amp
BODY
The body is an all welded construction, fabricated from high hardness (min. 360 BHN) 1000 MPa (145 000 lbf/
in²) yield strength steel. A 25° tail chute angle provides good load retention without the tailgate.
Plate Thicknesses:
Floor and Tailchute..............................................14 mm (0.55 in)
Sides....................................................................12 mm (0.47 in)
Front....................................................................8 mm (0.31 in)
Volume:
Struck (SAE)........................................................13.8 m³ (18.0 yd.³)
Heaped 2:1 (SAE)................................................17.5 m³ (22.9 yd.³)
To Next Page
