STEP 15 - ATTACH THE SIDE COVERS
1. Remove the side covers and the bag of enclosed fasteners from the shipping box.
2. Position the first side cover to the side of Powerwall that matches its curve.
3. Insert the top edge of the cover, then push in to fasten the top spring clip.
4. Fasten the bottom spring clip second, for easiest fit.
5. Fasten the middle spring clip. Verify that the entire length of the side cover is tucked
completely under the edge of the front cover.
6. Repeat the installation steps on the opposite side for the other side cover.
Step-by-Step Installation Instructions
Step-by-Step Installation Instructions 25
To Next Page
Loading...
