Testomat 808 - Performance specifications; Indicators for Testomat 808 instruments

Performance specifications
8
Performance specifications
Testomat
®
808 is used for the automatic monitoring of residual total
hardness (water hardness) in water. The limit value to be monitored
is determined by the indicator selection.
 Limit values for residual hardness of 0.02 – 10.0 °dH* deter-
minable by indicator selection
 Analysis start:
- Automatic interval mode
(interval pause can be set from 0 – 60 minutes)
- External control
- Manual start
 Extended operating periods due to 500 ml indicator storage
bottle
 RS232 interface for optional firmware update
Indicators for Testomat
®
808 instruments
Indicators with various limit values are available for the application of
Testomat
®
808 instruments according to operational requirements.
Indicator
type
Monitoring
range
Limit value LEDs
(good/poor display)
Measuring result
(information on water quality)
300 – 330
Residual hard-
ness
0.02 – 10 °dH
“GOOD” green
Residual hardness < indicator limit
value
“POOR” red
Residual hardness > indicator limit
value
All indicator types are available in two bottle sizes (100 ml and
500 ml). Please refer to the section entitled “Testomat
®
808 spare
parts and accessories” on page 41 for a detailed list of the individual
indicator types with the respective article numbers.