Tevion 82663 - Program the Command Timer

Helpline No. UK/ North Ireland 0871 37 61 020 Rep. Ireland 1-800-992 508
Web Support www.medion.co.uk
Model Number: 82663
18
Command timer
The clock must be set for this timer.
You can use the command timer to program a function that is to run automatically at
a particular time within the next 24 hours. The command series can contain up to four
commands, the first command must always be the selection of a mode key.
The following keys are not available for the remaining three commands: the mode
keys, the joystick (arrows and OK), MACRO, SETUP, EXIT.
You can create four command timers (Timer 1, Timer 2, Timer 3, Timer 4).
When the command is run this timer is automatically deleted.
Program the command timer
Example: This is how to program a command timer to control a recording on a DVD
recorder.
 Keep the SETUP key pressed down for approx. 3 seconds,
until
CODE SETUP appears.
 Press SETUP briefly twice more to open TIMER SETUP.
 Press OK The SLEEPTIMER TV menu is displayed.
 Use the arrows to select  the TIMER 1 SETUP menu
3
.
 Press OK" The
TIMER 1 SET display appears.
 Press OK The time when the command will be run appears.
The hours flash.
 Use the arrows to set  the hour and confirm by pressing
OK. The minutes flash.
 Use the arrows to set  the minutes and confirm by
pressing OK.
 The
TIMER 1 MODE? display prompts you to enter the command.
Use the mode key to select the device on which the command
should be performed.In our example, DVD if the DVD recorder
was programmed on this key.
 Press OK. You are prompted to make the first entry
TIMER 1
KEY1
. Enter the first command. In our example: Use the number
keys to select the programme. If no other input is needed,
press OK or EXIT.
 The
TIMER 1 KEY2 display appears. Enter the second
command.In our example: Press the Record key. The
TIMER 1
KEY3
display appears after the second command.
In our example, press the Record key again.
 The
SUCCESS confirmation message appears along with the
bell symbol after the third command.
 Lay the universal remote control down so that it is pointing towards the device and is
not obstructed.
You can cancel programming at any time by pressing EXIT.
3
If a command timer has already been entered, then TIMER 2, 3 or 4 appears here.