Texas Instruments bq78350-R1

0x00 ManufacturerAccess() and 0x44 ManufacturerBlockAccess() www.ti.com
112
SLUUBD3D–September 2015–Revised September 2018
Submit Documentation Feedback
Copyright © 2015–2018, Texas Instruments Incorporated
SBS Commands
SLPAD (Bit 26): ADC Measurement in SLEEP mode
1 = Active
0 = Inactive
RSVD (Bit 25): Reserved. Do not use.
INIT (Bit 24): Initialization after full reset
1 = Active
0 = Inactive
SLEEPM (Bit 23): SLEEP mode
1 = Active
0 = Inactive
XL (Bit 22): 400-kHz SMBus mode
1 = Active
0 = Inactive
CAL_OFFSET (Bit 21): Calibration Output (raw CC offset data).
1 = Active when MAC OutputShortedCCADCCal() is sent and the raw shorted CC data for
calibration is available.
0 = When the raw shorted CC data for calibration is not available.
CAL (Bit 20): Calibration Output (raw ADC and CC)
1 = Active
0 = Inactive
RSVD (Bit 19): Reserved. Do not use.
AUTH (Bit 18): Authentication in progress
1 = Active
0 = Inactive
LED (Bit 17): LED Display
1 = LED display is on.
0 = LED display is off.
SDM (Bit 16): SHUTDOWN triggered via command
1 = Active
0 = Inactive
SLEEP (Bit 15): SLEEP mode conditions met
1 = Active
0 = Inactive
XCHG (Bit 14): Charging disabled
1 = Active
0 = Inactive
XDSG (Bit 13): Discharging disabled
1 = Active
0 = Inactive
PF (Bit 12): PERMANENT FAILURE mode status
1 = Active
0 = Inactive
SS (Bit 11): SAFETY mode status
1 = Active