Texas Instruments bq78350-R1

0x00 ManufacturerAccess() and 0x44 ManufacturerBlockAccess() www.ti.com
116
SLUUBD3D–September 2015–Revised September 2018
Submit Documentation Feedback
Copyright © 2015–2018, Texas Instruments Incorporated
SBS Commands
15 14 13 12 11 10 9 8
CAL_EN LT_TEST CB_TEST AFE_DD_TEST RSVD RSVD LED_EN SAFE_EN
7 6 5 4 3 2 1 0
BBR_EN PF_EN LF_EN FET_EN RSVD DSG_TEST CHG_TEST PCHG_TEST
LEGEND: R/W = Read/Write; R = Read only; -n = value after reset
CAL_EN (Bit 15): CALIBRATION mode
1 = Enabled
0 = Disabled
LT_TEST (Bit 14): LIFETIME SPEED UP mode
1 = Enabled
0 = Disabled
CB_TEST (Bit 13): Cell Balancing Test
1 = Enabled
0 = Disabled
AFE_DD_TEST (Bit 12): AFE Delay Disable Test
1 = Enabled
0 = Disabled
RSVD (Bits 11–10): Reserved. Do not use.
LED_EN (Bit 9): LED Display
1 = Enabled
0 = Disabled
SAFE_EN (Bit 8): SAFE Action
1 = Enabled
0 = Disabled
BBR_EN (Bit 7): Black Box Recorder
1 = Enabled
0 = Disabled
PF_EN (Bit 6): Permanent Failure
1 = Enabled
0 = Disabled
LF_EN (Bit 5): Lifetime Data Collection
1 = Enabled
0 = Disabled
FET_EN (Bit 4): All FET Action
1 = Enabled
0 = Disabled
RSVD (Bit 3): Reserved. Do not use.
DSG_TEST (Bit 2): Discharge FET Test
1 = Discharge FET test activated
0 = Disabled
CHG_TEST (Bit 1): Charge FET Test
1 = Charge FET test activated
0 = Disabled