Texas Instruments bq78350-R1

www.ti.com LED Configuration Register
87
SLUUBD3D–September 2015–Revised September 2018
Submit Documentation Feedback
Copyright © 2015–2018, Texas Instruments Incorporated
Display Port
LEDCHG (Bit 2): Enables LED during charging. For LCD, the display is always active so this setting has
no effect.
1 = Activates display due to charging current
0 = Does not activate display due to charging current (default)
LEDRCA (Bit 1): Enables flashing of the LED display when the [RCA] flag in BatteryStatus()
BatteryStatus is set.
1 = If the LED display is activated when [RCA] is set, the display flashes with LED Flash
Period.
0 = The LED display is not activated due to [RCA] being set. (default)
LEDR (Bit 0): Enables activation of the LED display on device-reset exit. For LCD, the display is
activated on device-reset exit; same as setting LEDR = 1.
1 = LED display is not activated on exit from device reset.
0 = LED display is activated (simulates a DISP transition) on exit from device reset (default).