154 Chapter 4: Development Tools
TI-83 Plus Developer Guide Third Release May 28, 2002
Link Settings
The Link Settings dialog box allows you to configure communications settings. Selecting
Enable simulator to calculator link will allow you to send and receive data to an external device
(calculator, CBL, CBL2, CBR, etc.) through the TI-GRAPH LINK cable.
Troubleshooting link errors:
1. Make sure that the cable is firmly connected to both the serial port and the external
device.
2. Make sure that the serial port is enabled, and that the COM port is not in use by
another device.
3. Close any conflicting software programs (TI-GRAPH LINK™, TI Connect™ software,
some personal organizer software, etc.).
For more information, refer to the TI-GRAPH LINK™ or TI Connect™ documentation.
To Next Page
Loading...
