INS760EN-7 12/91
SmartCom V3.0 LED Functionality
SmartCom V3.0 has new LED functionality to ensure consistency between the
SmartCom and the upcoming SmartCom 4G.
With SmartCom V3.0 the Power LED has been replaced with a Mobile Comms
status LED, a feature of the upcoming SmartCom 4G
The Power LED was unnecessary as at least one other SmartCom LED is always
active, indicating power to the unit
Principle differences
The POWER LED is replaced by a Mobile Comms LED (only used on SmartCom4G)
The power up sequence for Version 3.00.xx product is a little different, With added
features the Smartcom takes slightly longer to initialise. An approximate sequence
is outlined below.
If in doubt just be patient!
Time (sec) LED Display Actions
At power up No LED's are lit
+00:15
Cloud LED flashes
continuously
+00:30
Cloud LED goes out
LES's will remain off
+00:30
Wait 30 seconds after
Cloud LED goes out
Enable Wifi AP mode-
Press & hold (10s)
To Next Page
Loading...
Need help?
General
