Textron Bell 212 - Page 112

BHT-212-MM-1
5-00-00
26 JUN 2013 Rev. 14 Page 89
Export Classification C, ECCN EAR99
c. Driveshaft sections and attaching hardware for
condition and security.
d.
Coupling clamps for cracks in or near bolt lugs. Clamps
for proper position
.
Chapter 65 8. Intermediate gearbox:
a. Chip detector for debris.
b. Clean chip detector.
c. Functionally test chip detector electrical circuit.
Chapter 12 d. Service gearbox as required.
Chapter 65 9. Tail rotor gearbox:
a. Chip detector for debris.
b. Clean chip detector.
c. Functionally test chip detector electrical circuit.
Chapter 12 d. Service gearbox as required.
Chapter 64 10. Tail rotor hub and blade assembly:
a. Torque check nuts on tail rotor blade retention bolts.
b. Torque check tail rotor hub retaining nut.
Chapter 18 c. Dynamically balance tail rotor.
Chapter 62
MAIN ROTOR BLADE INSPECTION SYSTEM (BIS) (IF
INSTALLED)
— Inspect
BHT-212-CR&O and
Chapter 96
1. Test detector unit.
2. Perform continuity check on blade conductor circuits.
SCHEDULED INSPECTIONS
5-13. 300 HOURS — PART B (CONT)
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER