BHT-212-MM-1
5-00-00
Page 106 Rev. 14 26 JUN 2013
Export Classification C, ECCN EAR99
Torque check is the term used when the
specified torque or standard torque plus
tare torque is applied to a fastener in a
tightening direction. The specified or
standard torque plus tare torque would
have been previously recorded. However, if
the specified or standard torque and tare
were not recorded, use the minimum
specified or standard torque, plus the tare
torque listed in the BHT-ALL-SPM,
Chapter 2.
Looseness may occur until components seat
themselves and fasteners are tightened. This is not
cause for disassembly, however the fastener will have
to be torque checked again at the same scheduled
interval set for the first torque check until the assembly
is completely seated.
For additional information, refer to BHT-ALL-SPM. If
any confusion exists, or a clarification is desired,
contact Product Support Engineering.
Torque Check Requirements
MANUAL
SPECIFIES
SUGGESTED TIME
FRAME TO
ACCOMPLISH
100 hours 90 to 110 hours
50 hours 40 to 60 hours
25 hours 20 to 30 hours
10 hours 5 to 15 hours
To Next Page
Loading...
