Textron Bell 212 - Each 50 Hours of Component Operation

BHT-212-MM-1
5-00-00
26 JUN 2013 Rev. 14 Page 131
Export Classification C, ECCN EAR99
SPECIAL INSPECTIONS
5-25. EACH 50 HOURS OF COMPONENT OPERATION
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
DATE: __________________W.O. _____________________
FACILITY: __________________________________________
HELICOPTER S/N: ___________________________________
REGISTRY NO.: _____________________________________
TOTAL TIME:_______________________________________
SIGNATURE:________________________________________
NOTE
Accomplish each 50 hours of component operation.
Chapter 63 TRANSMISSION
— Detailed Visual Inspection
1. Transmission 212-040-001-115, -119, -123, and -127 —
remove internal filter and sump chip detector. Visually inspect
filter element and detector for metallic chips, particles, and
contamination. If contamination or debris is found, investigate to
determine cause. Thoroughly clean and reinstall detector and
filter. Service transmission oil system (Chapter 12) to proper
level.
NOTE
Accomplish each 50 hours of component operation.
Chapter 65 TAIL ROTOR PITCH CHANGE SHAFT (CROSSHEAD)
BEARING 212-010-762-001
— Inspect
NOTE
The following inspection does not apply to helicopter
S/N 30712 and subsequent or to helicopter S/N
30711 and prior, after modification by SI 212-49.