BHT-212-MM-1
5-00-00
Page 58 Rev. 14 26 JUN 2013
Export Classification C, ECCN EAR99
2. Tailboom and fin driveshaft covers for condition and
attachment.
3. Tailboom and fin external skin for damage, corrosion, and
cracks.
4. Tailboom access panels and covers for condition and
attachment.
5. Tailboom baggage compartment door for condition,
attachment, and latching.
6. Tailboom baggage compartment interior for damage and
corrosion.
7. Tailboom interior bulkheads and stringers for cracks and
corrosion.
8. Intermediate gearbox mount pad for damage and
corrosion. Tail rotor gearbox mount pad for damage and
corrosion.
9. Tailboom exterior bonded panels adjacent to baggage
compartment for damage, delamination, and corrosion.
Chapter 28 FUEL SYSTEM
1. Inspect fuel cells for condition and serviceability. Verify
self-sealing gum of the lower cells has not been activated.
Repairs to be accomplished at an authorized facility.
Chapter 67
BHT212-CR&O
BHT-212-SI-4
BHT-212-SI-89
TB 212-87-98
FLIGHT CONTROLS
1. Disassemble pilot and copilot collective sticks (if installed)
to the extent necessary to remove throttle twist grips.
2. Referring to Figure 5-3, visually inspect stick tube for
cracks using a 3X magnifying glass and a bright light. Pay
particular attention to the base of the throttle slots that form the
twist grip stops.
3. If a crack is found replace stick tube.
4. Reassemble pilot and copilot collective sticks (if installed).
5-11. 3000 HOURS/5 YEARS — PART A (CONT)
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
To Next Page
Loading...
