en-42
7 OPERATION
7. Disengage the cutter motors and raise the implements when crossing paths or roads. Look out for traffic.
8. Stop and inspect the equipment for damage immediately after striking an obstruction or if the machine
begins to vibrate abnormally. Have the equipment repaired before resuming operation.
9. Slow down and use extra care on hillsides. Read Section 3.7. Use caution when operating near drop off
points.
10. Never use your hands to clean cutting units. Use a brush to remove grass clippings from blades. Blades
are extremely sharp and can cause serious injuries
11. Always operate the machine with grass catchers attached to prevent discharge from the centre unit hitting
the operator.
CAUTION
Remove All Debris From The Site Before
Mowing. Enter A New Area Cautiously
Always Operate At Speeds That Allow
You To Have Complete Control Of The
Mower.
CAUTION
Before You Clean, Adjust, Or Repair
This Equipment, Always Disengage All
Drives, Lower Implements To The
Ground, Engage Parking Brake, Stop
Engine And Remove Key From Ignition
Switch To Prevent Injuries.
WARNING
DO NOT USE ON SLOPES GREATER THAN 16°
To Next Page
Loading...
Need help?
General
