en-60
8 MAINTENANCE & LUBRICATION
8.6 AIR FILTER - GASOLINE_______________________________________________
NOTICE
DO NOT use bent or dented air cleaner housing.
DO NOT use bent or dented air cleaner elements.
IMPORTANT!
WE RECOMMEND THAT THE FILTER ELEMENT BE REPLACED BEFORE ENGINE PERFORMANCE IS
AFFECTED. THIS MAY OCCUR EARLIER IN DUSTY CONDITIONS.
CHECKING THE ELEMENT
To check for damage, pin holes, etc. shine a light source into the end of the element. If light CANNOT be seen
through the paper, a new element should be installed. Likewise, if pinholes of bright light appear in the paper, the
element should be replaced.
Pre-Cleaner
To clean the pre cleaner, separate it from the cartridge and wash in liquid detergent and water. Squeeze dry in a
clean cloth.
Removing / Installing Air Cleaner
1. Unhook clips on both sides of cover and remove
cover.
2. Remove knob and plate. Carefully remove air
cleaner assembly to prevent debris from entering
carburettor.
3. Reassemble clean (or new) pre-cleaner on clean (or
new) cartridge.
4. Reinstall air cleaner assembly, plate and knob.
5. Replace cover and reattach clips to body.
CAUTION
DO NOT use pressurized air or solvents to
clean cartridge. Pressurized air can damage
cartridge; solvents will dissolve cartridge.
A. Cover, B. Clips, C. Plate, D. Knob
E. Cartridge, F. Foam Pre-Cleaner, G. Body
To Next Page
Loading...
