en-64
8 MAINTENANCE & LUBRICATION
8.12 ENGINE COOLANT - DIESEL
Check Engine Coolant Level
(a) The level of coolant in the expansion tank (C) should
be between the MAX and MIN level indicators when
cold.
(b) If topping up is required, remove the plastic cap and
top up using the correct anti-freeze mixture.
(c) Replace the plastic cap when finished.
Changing Coolant
(a) To drain coolant, open cock on engine block and remove hose from radiator.
(b) Close drain cock on engine block and replace hose back on to radiator. Ensure all hose clips are tight.
(c) Refill the cooling system with the correct anti-freeze mixture. Fill system through expansion tank.
(d) The level of coolant in the expansion tank should be between the MAX and MIN level indicators when cold.
(e) Run the engine for approximately 5 minutes or until the thermostat opens.
(f) Check level of coolant in expansion tank and top up if necessary
CAUTION
Contact With Anti-freeze Can Damage
Your Skin. Use Gloves When Working
With Anti-freeze. If You Come In
Contact With Anti-freeze, Wash It Off
Immediately.
CAUTION
Dispose Of Used Anti-freeze in Accordance With
Local Regulations
To Next Page
Loading...
Need help?
General
